The K250 console is a permanent magnet device with controlled forceof the gravity. In the "off" condition, the console develops a force of attraction equal to 15-18 kgf. The presence of this force simplifies the installation of the console on the object: the console can be simply "sticked" to the damaged object. The sealing unit is installed on a carriage, which makes it possible to bring the sealing element directly on the leak. The carriage provides the ability to move the sealing unit in the longitudinal direction by a stroke of 15 mm, in the transverse direction - 20 mm and tilt the sealing unit in the longitudinal in the range of angles from 90 to 45 degrees. The set of delivery includes two types of sealing element: a cone and a 20 mm gasket. Replacing one sealing element with another takes just few seconds. A cone made for sealing round holes, and a flat gasket made for cracks or a group of small fistulas. The console is installed near the leak. The surface to which the magnetic block will be attached must be cleaned from dirt and coating. By rotating the handle, the magnetic block is "turned on". The sealing element need to bring to the hole to seal and the leak is can be eliminated by rotating the screw. Product technical characteristics: Type – Console unit Pressing force of the magnetic blocks to the metal surface - Not less than 250 kgf Diameter of the sealed tank (pipeline) - Not less than 400 mm Maximum diameter of the sealed gap - At a pressure of 25 atm - not less than 10 mm The range of inclination of the sealing unit in the longitudinal plane - From 90 to 45 degrees Installation time, min - 1-2 Required amount of workers - 1-2 Dimensions, mm - 275х121х151 Weight, kg - 3.4 Service life – At the very least 10 years.