IDP. CO. LTD

IDP has been working with a number of motor manufacturers for a long time. Whether it is a DC motor, a stepping motor or a brushless motor, our experience with various motors allows us to select the most suitable one to pair with the gearbox for the application.

After many research trials, IDP found that if the properties of the stamping parts are applied well, they can greatly enhance the performance of the gearbox. As an example, the bottom cover of a gearbox can be made by a stamping plate, which can both tighten the tolerance of the center distance for gears, and increase the overall strength of the gearbox.

O-rings currently on the market often fail to meet the sealing requirements of IDP, especially with regard to the sealing effect on the rotating shaft. As a result, IDP has developed its own line of well-sealed, wear resistant O-rings to enhance the efficiency of the gearbox and the pump.

IDP utilizes special engineering plastics to make low-friction and high strength nuts. We also adjust thread parameters to minimize the gap. The screw nut set we produce can replace most of the applications of ball screws for just a third of the cost.

With more than 30 years of experience in gear motor design, IDP team is committed to designing the best drive system for customers. Our engineers specialize in designing high-efficiency and low-noise gearboxes. In addition to gear accuracy, there are many other factors to consider, such as gear clearance optimization, appropriate match of gear types and materials, tooth profile adjustment, seal design, appropriate selection of greases, bearings and bushings, etc.   We understand that only good gearbox design can achieve the best balance between output torque, efficiency, durability, volume and weight.   1. A large overall ratio can be achieved with only a few stages 2. Good mesh effectiveness 3. Operate silently and smoothly 4. Self-locking

With more than 30 years of experience in gear motor design, IDP team is committed to designing the best drive system for customers. Our engineers specialize in designing high-efficiency and low-noise gearboxes. In addition to gear accuracy, there are many other factors to consider, such as gear clearance optimization, appropriate match of gear types and materials, tooth profile adjustment, seal design, appropriate selection of greases, bearings and bushings, etc.   We understand that only good gearbox design can achieve the best balance between output torque, efficiency, durability, volume and weight.   1. High load capacity 2. Higher stability 3. Low inertia