ООО ПКФ ПРОТЕМ

Designed for simultaneous punching of 4-corner segments in the shelves of a U-shaped profile, punching a tongue and punching holes for further connection of the ends of the profile into a frame. They consist of: a rigid frame on which the press blocks with stamps are mounted, an additional movement mechanism, a device for removing cut profiles, hydraulic equipment, which includes a hydraulic station, an electrical cabinet with a control panel. The blank of the U-shaped profile is installed manually on the dies and positioned along the stops. After performing all operations, the profile is automatically removed from the installation.

Designed for firing ceramics and other materials. They consist of a bed, a casing, a heating chamber, lining with refractory and heat-insulating materials, an electrical cabinet. Control from a stand-alone console. Heating of the furnace is electric. The heating chamber has three heaters: two heaters at the sides and one heater at the bottom of the furnace. Coil heaters are attached to ceramic tubes. Heater material - fechral Ø 4 mm.

Designed for firing ceramics and other materials. It consists of a bed, a casing, a heating chamber, lining with refractory and heat-insulating materials, an electrical cabinet. Control from a separate control panel equipped with a microprocessor-based temperature control system in the furnace. At the request of the Customer, the furnace can be equipped with an electromechanical drive for the bogie hearth.

Designed for firing powder materials. They consist of a lined heating chamber, inside of which a pipe, heated by silite heaters, rotates, a loading device and a control panel. The pipe is supported by four support rollers and a chain drive. The loading device is installed on support wheels with which it can be rolled away from the furnace in case of repair. The inclination of the furnace towards the unloading side can be changed within the range from 0 to 3 ° C. The work is controlled from the console. The gases formed during the firing of powders are sucked off through a branch pipe connected to the shop ventilation system.

Designed for drying bulk materials in various industries: chemical, construction, paint and varnish, powder metallurgy, etc. Hot air supplied to the drying zone from a heat generator is used as a heat carrier. Evaporation products are removed through an air duct, which is connected to the workshop exhaust ventilation through a branch pipe. The characteristics of the drying drum can be changed for the technological tasks of the Customer's production. On request it is completed with a heat generator of any type. Electric or gas, rated thermal power of gas heat generators from 0.315 MW. The installation includes: frame, drum, support station, drive station, loading bunker, unloading bunker.