Specifications:   Rated power, VA 12500     Maximum current, A 63     Input voltage range, V 90 - 285     Output voltage range, V 220+/- 8%     Stabilization type relay     Accuracy output voltage,% 8     Adjustment stepwise     Distortion sine wave no     Operating range t ° C -30 - +50     Cooling forced     Network Connection Method terminal block     Housing metal     Protection against short circuit +     Lightning protection +     Overall dimensions, cm 46x29x19     Weight, kg. 23   The undervoltage voltage stabilizer 12500VA SUNTEK Platinum is the best choice when looking for a reliable, high-quality stabilizer capable of making 220 Volts from 100 Volts. It is possible to install this model for the whole house (the total load should not exceed 12 kW) by connecting household or house appliances and technical equipment (pumping stations, septic tanks, heaters, etc.). Platimun series stabilizers can be used in production, in auto repair shops, farms as a supplier of reliable electricity with a voltage of 220 volts. The stabilizer is made in a metal case and can be placed horizontally on the legs, or vertically on the wall (mount included with the stabilizer). A powerful coil, a relay in the amount of 5 pieces, a data management card for the relays are the three main components that make it possible to obtain the stated characteristics of the SUNTEK Platinum stabilizers of this series. Relay stabilizers do not require maintenance and additional costs, it saves users time and money. From the SUNTEK relay stabilizers, the Platinum series models differ in addition to having a more powerful coil and 5 relays also with auxiliary equipment: - forced cooling is carried out by 2 fans installed on both sides of the coil. - bipolar circuit breaker - allows to divide the increased currents passing through the stabilizer at low input voltage. The SUNTEK 12500 Platimun voltage stabilizer will work even from 90 volts, but it should be understood that the load level must be less than the nominal. Its full-fledged characteristics of the stabilizer begins to perform from 100 volts. At a voltage in the range of 270-285 Volts, the actual output voltage will also be shown on the display. But when reaching 285-288 Volt, the stabilizer will immediately turn off by turning off all devices (the letter “H” on the display), since the output voltage will be very high and dangerous for the equipment.