Rated power, VA
Maximum current, A
Input voltage range, V
90 - 285
Output voltage range, V
Accuracy output voltage,%
Distortion sine wave
Operating range t ° C
-30 - +50
Network Connection Method
Protection against short circuit
Overall dimensions, cm
Voltage stabilizer SUNTEK 16000 VA Platinum is a popular model of the stabilizer, operating already at 100 volts of input voltage. Solves the difficult task - to work at full nominal even at very low voltage. SUNTEK Platinum relay stabilizers fully operate from 140 V input, but there are and there will be countries where there is not even 140 V in the electrical network, or the voltage periodically jumps. For these regions and were developed and launched a series of stabilizers Suntek series "Platinum".
To cope with the task of this series of stabilizers allow features, updates and additions that distinguish them from the classic relay stabilizers SUNTEK (Santek).
First of all, it is a more powerful coil (since the currents are higher compared to the network with voltage higher than 140V) installed in the stabilizer.Secondly, it is the presence of 5 (five) relays to equalize the output voltage to the allowed level.Thirdly, this forced cooling is implemented in two fans (coolers) that turn on when the winding reaches a temperature of 70 degrees Celsius.Fourthly, the on-off stabilizer is carried out by a bipolar machine,11000VA NN - 25 Amp automat (25x2 = 50A),in 12500VA NN - 32A (32x2 = 64A),16000VA NN - 40A (40x2 = 80A),20000VA NN - 50A (50x2 = 100A). The bipolar automatic machine - additional reliability at transients in the automatic machine and at operation of the stabilizer.
Also, the SUNTEK stabilizer of the relay type 16000VA of the Platinum series, like all relay stabilizers, has a metal case (with holes for mounting on the wall and legs for horizontal installation), digital indication of the input and output voltage, on-delay (protection against false positives), short-circuit protection , overload protection, overheating protection, protection of the connected equipment against undervoltage, against overvoltage. Automatic shutdown and power up during a critical change in the supply network - if the input voltage suddenly exceeds 285V, the regulator will disconnect the load and will be in the standby mode of normalization of the network (below 285V), after which it will automatically turn on, and also at a critical voltage drop. The temperature mode of the stabilizer is from minus 30 to plus 50, the degree of protection of the enclosure is IP20.
3 year warranty
The SUNTEK 16000 Platinum voltage stabilizer will work even from 90 volts, but it should be understood that the load level must be less than the nominal. Its full-fledged characteristics of the stabilizer begins to perform from 100 volts. At a voltage in the range of 270-285 Volts, the actual output voltage will also be shown on the display. But when reaching 285-288 Volt, the stabilizer will immediately turn off by turning off all devices (the letter “H” on the display), since the output voltage will be very high and dangerous for the equipment.